AFE 01-04 (LB7) 6.6L Duramax Stage 1 Magnum Force Intake

AFE - Stage One Intake - DURAMAX

MAGNUM FORCE INTAKE KIT (without extension tube)

25+ Rear Wheel Horsepower Gain

Up to 4% increase in fuel economy. (w/built in mass-air meter housing)

Why Stage 1?
With the Magnum FORCE Stage 1 intake system, we replace the stock air box and the stock air filter. By replacing the restrictive air box and air filter, there is a noticeable improvement in airflow and power. However, Stage 1 retains the stock intake tract.

Our engineers can develop a Stage 1 system kit quickly because we are not tackling the stock intake tube, which often interfaces with the factory Mass Airflow Sensor. It is still a challenge to make sure that the Check Engine Light does not come on but not as challenging as when you are replacing the entire intake tract.

Block Out Hot Engine Air
Since we are still using the stock intake tube, the size of the filter inlet diameter is limited by the diameter of the stock tube. However, our engineers still managed to increase the filter inlet diameter whenever possible.

In designing out the stock air box, we always try to design in the largest air box that we can. When replacing the stock intake tube as we do in our Stage 2 systems, you have more flexibility since you can change the tube configuration. However adapting to the stock intake tube forces some limitation on the design. Even with adapting to the constraints of the stock intake tube, we are careful to use that stock mounting points. There is no need to cut or drill anything when you install our kits.

At first glance you probably won’t notice the unique features that we design into each air box. They are there for a purpose, either to make your job of installing the system easier or to improve the performance of your vehicle. Here are a few of the features that distinguish aFe from our competitors.

16-gauge powder-coated steel for durablility.

Trim sealed to seal out hot engine air.

Pre-positioned PEM-nuts for easier installation.

Welded and pre-assembled sheet metal.

Pre-positioned opening for stock attachments.

3-angle velocity stack adaptor on some applications.

Powder-coated covers on some applications.

As you can see, we put in a lot of effort to designing each air box to fit each vehicle. It takes us a little more time and effort but we do it to make the job of installing our systems easier.

Bigger Is Better

Since we make our own filters instead of buying off-the-shelf sizes , we can design our filters to suit each application. Depending on the design of our air box, we can make the filter taller or fatter or oval as necessary. By designing the largest filter for the largest air box, we can insure that the vehicle is getting the maximum amount of air.

Our Stage 1 intake system uses our radial universal clamp-on filters. We design in an inverted top on some of the filters on the Stage 1 systems to increase filtration surface area and airflow. One of the special characteristics of our filters is the full or modified velocity stack that is built into our universal cone filters. This velocity stack allows the air to curve around the edge of the filter and enter the intake tract without loss of velocity. We have conducted tests where there is more airflow with a full-velocity stack filter than with a straight tube and no filter. If you’re ever in the neighborhood, come by and we’d love to show you.

Here are common characteristics of AFE air filters:

100% poly urethane construction – Durable, resistant to high temperature and chemicals.

Deepest pleats – Greater flow and dust holding capacity.

Rounded pleat geometry – Better airflow characteristics.

Washable/reusable filter media – Longer service life.

Full or modified velocity stack - Better, more airflow.